Table of Contents
Advertisement
HAREWARE INSTALLATION
2.2.4 Installing the Memory Modules (DIMM)
■ This mainboard has three sockets available for 184-pin DIMMs. They must
be 3.3 volt Un buffered Synchronous DDR RAMs (DDR RAM).
■ DIMM Sizes supported:128MB, 256MB, 512MB.
■ A total of 2 DIMMs can be installed for a maximum RAM capacity of 2GB.
To insert the DIMMs, the modules must be oriented in the correct way. Notice the notches
of the DIMM. Align these notches as shown in the diagram below. Gently push the DIMM
until the retainers on both sides of the socket lock the module in place. To remove a DIMM,
push the retainers outwards to release the module then pull the module out of the socket.
Total Memory Sizes With Unbuffered DDR DIMM
Devices used DIMM
64Mbit (2Mx8x4 banks)
64Mbit (1Mx16x4 banks)
128Mbit (4Mx8x4 banks)
128Mbit (2Mx16x4 banks)
256Mbit (8Mx8x4 banks)
256Mbit (4Mx16x4 banks)
512Mbit (16Mx8x4 banks)
512Mbit (8Mx16x4 banks)
1DIMM x64 / x 72
128 Mbytes
32Mbytes
256Mbytes
64Mbytes
512Mbytes
128Mbytes
1Gbytes
256 Mbytes
User's Manual
2DIMMs x64/ x 72
256 Mbytes
64 Mbytes
512 Mbytes
128Mbytes
1GBytes
256 Mbytes
2GBytes
512 Mbytes
1.TheDIMM Slot has a notch, so
the DIMM memory module can
only fit in one direction.
2.Insert the DIMM memory
module vertically into the
DIMM Slot. Then push it down.
3.Close the plastic clip at both
edges of the DIMM Slots to
lock the DIMM module.
19
Advertisement
Table of Contents
