Periodic Maintenance
Situations Requiring Maintenance
When installing the machine
When replacing the spindle unit
When the machine has not been used for a pro-
longed period
Before you start using the machine in low room
temperature
When installing the machine in a different location
When the milling position is misaligned
When symptoms such as a hole in the Z direction
occurs
Once a month
When the work time of the spindle exceeds 200
hours
When water or dust accumulates on the regulator
Replacing Consumable Parts
A replacement manual is included with purchased products. For information on how to perform replacement, refer to the
replacement instruction manual included with the part.
Part name
Spindle unit
Collet
Spindle belt
36
3. Maintenance
Replacement time / Guideline
When the total work time of the spindle exceeds 2,000 hours (with slight
variation depending on the work situation).
You can use VPanel to view the total work time of the spindle.
P. 9""Maintenance" Tab"
The replacement spindle unit comes with a collet and belt.
If the collet is deformed
If an overload error or other error occurs, the collet may have become deformed.
If the spindle belt is worn
P. 37"Running In the Spindle (Warm-up)"
P. 38"Correcting the Milling Machine"
P. 37"Running In the Spindle (Warm-up)"
P. 38"Correcting the Milling Machine"
P. 41"Retightening the Collet"
P. 44"Care of the Regulator"