Roland DWX-51D User Manual page 63

Error number Message
Milling data error.
103D-0000 The milling bur has
not reached the
milling position.
Situation/error cause
If the milling bur is too
short, or if the angle of
the A axis and B axis are
too large, the milling
bur may not reach the
milling position in the Z
direction.
Responding to Error Messages
Action
1. Press and hold the operation button on the
built-in panel. This will clear the error.
2. Check the milling bur length and the position
of the milling bur holder.
P. 26"STEP 2: Attaching the Milling Bur"

3. Review the CAM settings, and decrease the
angles of the A axis and the B axis.
4. Troubleshooting
63