Step 2: Attaching The Milling Bur - Roland DWX-51D User Manual

Starting Milling

STEP 2: Attaching the Milling Bur

Procedure


Slide the milling bur through the milling bur holder, and determine the proper position.
Insert the milling bur as in the figure, and make sure that both ends are within the areas of the milling bur positioner holes.
Secure the mounting screw using the hexagonal screwdriver.

Set the milling bur in the ATC magazine.
Insert firmly as far as possible. Up to 10 milling burs can be set. The stocker numbers are shown on the surface of the
magazine.
26
2. Milling
Orient with the screw
hole facing up
Milling bur holder
Milling bur
positioner
Mounting screw
Both ends of the milling bur
are within the A and B areas.
Attach the milling bur holder to the milling bur
positioner.
Insert the milling bur holder oriented as in the figure, and
attach it so that it reaches the back of the hole.
Insert the milling bur firmly.
OK Not OK