Milling - Roland DWX-51D User Manual

16

2. Milling

Using / Reading the Built-In Panel .....................17
Using / Reading the Built-In Panel .........................................17
Statuses Indicated by Status Light Color ...............................17
Switching the Power On or Off ...........................18
Switching the Power On ........................................................18
Switching the Power Off ........................................................18
Preparing for Milling ...........................................19
Preparing a Workpiece (Usable Workpieces) ........................19
Preparing a Milling Bur (Usable Milling Burs) .......................19
Preparing Compressed Air (Setting the Regulator) ...............19
Starting Milling ....................................................20
STEP 1: Mounting the Clamp to the Workpiece ....................20
STEP 2: Attaching the Milling Bur ..........................................26
STEP 3: Outputting Milling Data ............................................27
STEP4 The workpiece from the clamp ..................................29
Automatically Switching Out the Worn Milling Bur (Intelligent Tool
Control) ..................................................................................30
Aborting Output ......................................................................31
Removing Milling Data in Standby from the Output List ........31