Using / Reading The Built-In Panel; Statuses Indicated By Status Light Color - Roland DWX-51D User Manual

Using / Reading the Built-In Panel

Using / Reading the Built-In Panel

ERROR
PAUSE
POWER
CANCEL
Operation button

Statuses Indicated by Status Light Color

Status
light
Operation button
Flashes when an error has occurred.
Illuminates when operation is paused.
This lights up when the power is turned on.
Flashes when data is being cancelled and during initialization.
Milling data received while this light is flashing will be cancelled.
Pressing this button during milling will pause or restart the machine.
Pressing and holding this button during milling will abort milling or clear some
errors.
Pressing this button in standby will rotate the rotary axis position 180 degrees. The
button will flash during initialization, spindle rotation. The button will illuminate
under any other status while the power is on.
Blue
White
Yellow
Red
Off
The machine is in standby or initializing.
The light will also turn off if no operation is
performed for 30 seconds when in standby,
causing the machine to sleep.
When lit white, milling is being performed or
has been paused, or the front cover is open.
Also flashes when the dust collector is in
standby.
When lit yellow, an error has occurred, and the
machine has been paused. Check the error
details shown on VPanel. Press the operation
button on the built-in panel to resume milling.
When lit or flashing red, an error has occurred
and milling has been stopped. Milling cannot
be resumed.
Check the error details shown on VPanel. When
lit red, pressing and holding the operation but-
ton on the built-in panel will abort milling and
return the machine to the ready status. When
flashing, turn off the power once and start up
the machine again.
The light turns off when the power is turned
off or the machine in the sleep state.
17
2. Milling