VFC 3610 / VFC 5610
2.2.2 Control Signal Connection
The following requirements are applicable to signal connection:
Flexible cables with wire end sleeves
●
Cable cross-section: 0.2...0.75 mm
●
Cable
cross-section
●
0.25...0.75 mm
2
Analog inputs AI1, AI2, +10 V, +5 V and GND: use shielded cables
●
RS485 communication: use shielded twisted pair cables
●
Recommendations on cable insulation stripping:
Please strip the insulation of control cables according to the dimensions given
below. Too long stripping may cause short circuit of adjacent cables; too short
stripping may lead to cables becoming loose.
Fig. 2-2: Cable insulation stripping length
DOK-RCON04-VFC-X610***-QU06-EN-P
2
when
using
connectors
Bosch Rexroth AG
Electric Installation
with
insulation
sleeves:
9/51