Connecting An External Display - Roland Vima RK-500 Owner's Manual

Connecting an External Display

fig.ConnectDisplay.eps
Rear of the VIMA's bottom panel
Types of display that can be connected
NOTE
Resolution
Horizontal scan rate
Vertical scan rate
Connector
Signal
Making Connections
NOTE
1. Switch off the VIMA and the display you'll be connecting (p. 25).
2. Connect the VIMA to your display.
Use a commercially available monitor cable to connect the VIMA's ANALOG RGB OUTPUT
connector to the analog RGB connector of your display.
3. Switch on the VIMA (p. 24).
4. Switch on the connected display.
ANALOG RGB
OUTPUT Connecter
In general, you can connect any display that is sold as a "multiscan monitor." However,
to be certain, please check the following specifications before you connect your display.
Before you make connections to other devices, you must turn down the volume of all
devices and turn off the power to prevent malfunctions or damage to your speakers.
For details on how to use your external display, refer to the owner's manual for your
display.
Monitor Cable
(Commercially available)
800 x 480 pixels or more
31.5 kHz
60 Hz
Three-row 15-pin D-sub type
Analog
Before You Play
External Display
31