Connecting An External Display Or Television - Roland AT900 Music Atelier Owner's Manual

Connecting an External Display or Television

Connecting an External Display
Displays That Can Be Connected to This
Instrument
In general, a great many of the VGA monitors and multiscan
monitors that are available on the market are compatible
NOTE
with this instrument. However, before you connect any
monitor, make sure it meets the following specifications:
Resolution
Horizontal scan frequency
Vertical scan frequency
Connector
Signal
Confirm that the display to be used is compatible with the
frequencies mentioned above. Using a display that is not
compatible with the above frequencies may result in
NOTE
incorrect image output when images move, and in certain
cases may even damage the display.
Display Cable
(commercial available)
800 x 480 pixels
31.5 kHz
60 Hz
3-row, 15-pin D-Sub type
Analog
Connecting with External Device
External Display
Making the Connections
To prevent malfunction and/or damage to speakers or other
devices, always turn down the volume, and turn off the
NOTE
power on all devices before making any connections.
1.
Turn off the power to the ATELIER and the
display to be connected (p. 24).
2.
Connect your display to the ATELIER.
Use display cable (sold separately) to connect the
display to the Video Out [RGB] jack on the ATELIER.
3.
Switch on the ATELIER (p. 24).
4.
Switch on the connected display.
For more on handling the external display, refer to your
display's owner's manual.
245