Usb Driver Settings; Changing The Usb Driver Settings (Usb Driver) - Roland Vima RK-500 Owner's Manual

USB Driver Settings

1.
Access the main screen.
If the main screen is not shown, press the [EXIT] button
several times to access the main screen.
fig.d-MainScreen.eps
2.
In the main screen, touch <Menu>.
The menu screen appears.
fig.d-Function-01-2.eps
3.
Touch <USB Driver>.
A screen like the following appears.
fig.d-Function-14.eps
4.
Touch
5.
Press the [EXIT] button when you're finished
making settings.
for "USB Driver."
6.
Turn the VIMA's volume to the minimum
setting. Next, switch off the power, then turn it
on again.
Changing the USB Driver Settings
(USB Driver)
Normally, you don't need to install a driver in order to connect
the VIMA to your computer via the USB connector. However, if
some problem occurs, or if the performance is poor, using the
original Roland driver may solve the problem. If you do so,
make the following setting to specify the USB driver you intend
to use before you install the driver.
Setting
Choose this if you want to use the standard USB
Generic driver that was included with your computer.
Normally, you should use this mode.
Choose this if you want to use a USB driver
Original
downloaded from the Roland website.
For details on downloading and installing the
original driver, refer to the Roland website.
Roland website: http://www.roland.com/
For details on connecting the VIMA to your computer
via the USB connector, refer to "Connecting Your
Computer" (p. 137).
Settings
Explanation
129