V-Link Settings (V-Link Setup) - Roland JUNO-G Owner's Manual

V-LINK Settings (V-LINK SETUP)

1.
Press [V-LINK] to access the V-LINK screen.
2.
Press [F6 (SETUP)].
The V-LINK SETUP screen appears.
fig.V-LINK-SETUP
3.
Use [ ] [ ] to move the cursor to the parameter you want to edit.
4.
Use the VALUE dial or [INC] [DEC] to set the value.
Parameter Value
Note Tx Channel A 1–16
Note Tx Channel B
Note Tx Channel C
D BEAM Assigns a V-LINK function to the D Beam controller.
OFF
ColorEQ Fore
ColorEQ Back
Scratch SW
Speed Knob
Total Fader
Cross Fader
BPM Sync SW
Clip Loop SW
Assign Knob
Fade Time SW
Visual Knob
AB SW
Tap SW
Total Select
FX Select
Play Pos
LoopStartPos
Loop End Pos
LayerModeSel
Dissolve Time
Color Cb Ctrl
Color Cr Ctrl
Brightness Ctrl
VFX1 Ctrl
VFX2 Ctrl
VFX3 Ctrl
VFX4 Ctrl
Fade Ctrl
* : On V-LINK compatible devices such as the Edirol DV-7PR/P-1, only Note Tx Channel A is used.
In motion dive .tokyo Performance Package, the Note Tx Channel corresponds as follows.
A: The MIDI channel that controls section A
B: The MIDI channel that controls section B
C: The MIDI channel that controls the MIDI note plug-in
5.
If you want to keep your settings, press [F6 (WRITE)].
6.
Press [F5 (EXIT)] or [EXIT] to return to the previous screen.
Explanation
Controls the V-LINK device. Specify the MIDI channel. (*)
The operation selected by [D BEAM] will occur regardless of whether
V-LINK is on or off.
CC1 (Modulation)
CC71 (Resonance)
CC3
CC8 (Balance)
CC10 (Panpot)
CC11 (Expression)
CC64 (Hold)
CC65 (Portamento)
CC72 (Release)
CC73 (Attack)
CC74 (Cutoff)
CC81 (General-6)
CC83 (General-8)
CC85
CC86
CC91 (Reverb)
CC92 (Tremolo)
CC93 (Chorus)
CC94 (Celeste)
CC73 (Attack)
CC1 (Modulation)
CC71 (Resonance)
CC74 (Cutoff)
CC72 (Release)
CC91 (Reverb)
CC92 (Tremolo)
CC93 (Chorus)
CC10 (Panpot)
About V-LINK
Used with motion dive .tokyo Performance Pack-
age
Used with the DV-7PR and similar devices.
173