Inputting Data One Step At A Time (Step Recording) - Roland JUNO-G Owner's Manual

Recording a Song (MIDI Track)
Auditioning Sounds or Phrases While
Recording (Rehearsal Function)
The Rehearsal function lets you temporarily suspend recording
during realtime recording. This is convenient when you want to
audition the sound that you will use next, or to practice the phrase
that you will record next.
1.
Begin realtime recording (p. 88).
The Realtime Rec Control window appears.
2.
Press [F5 (REHEARSAL)] or [REC].
The [REC] indicator will blink, indicating that you are in
rehearsal mode. In this state, nothing will be recorded when
you play the keyboard.
3.
To return to record mode, press [F5 (REHEARSAL)] or
[REC] once again.
92
Inputting Data One Step at
a Time (Step Recording)
Step Recording is the method of inputting notes and rests
individually, as if you were writing them onto a musical staff.
Inputting Notes and Rests
1.
Make sure that the preparations for recording have been
performed as described in "Before You Record a New MIDI
Track" (p. 87).
If you want to record into an existing song, load the desired song
into Temporary Song (p. 115). Then press SONG RECORDER
[BWD] or [FWD] to specify the measure at which you want to
begin recording. The measure at which recording will begin is
indicated by the "M=" in the upper right of each PLAY screen.
2.
Press [REC] twice, or hold down [SHIFT] and press [REC].
The [REC] indicator blinks, and the MIDI Rec Standby (Step
Rec) window appears.
3.
Make settings for step recording. Use [
move the cursor to the desired parameter, and use the
VALUE dial or [INC] [DEC] to set it.
Parameter Explanation
Rec Mode Select how recording is to take place.
MIX:
Mix-recording will be carried out. If a performance has al-
ready been recorded on the recording-destination track,
your newly recorded performance will be added to the exist-
ing performance without erasing it. Normally, you will
record using this method.
REPLACE:
Replace-recording will be carried out. If a performance has
already been recorded on the recording-destination track, it
will be erased as you record your new performance. Use this
when you want to re-record.
Start Point Specify the location (measure-beat-tick) at which recording
will begin.
4.
Press [F6 (NOTE)] or [PLAY].
The [REC] indicator lights, and the STEP REC screen appears.
] [ ] [ ] [ ] to