Flange Mounting - ABB ACS800-U4 Hardware Manual

38

Flange mounting

The flange mounting plate is factory assembled on the drive. With flange mounting,
the degree of protection is IP55 for the heat sink side and IP20 for the drive front
side. The drive front side must always be housed in a cabinet.
R6 with flange mounting plate
Connect a drive with flange mounting plate as follows:
1. Make the appropriate mounting and screw holes for the drive into the mounting
plate. The sizes and locations of the holes vary according to the frame size. See
chapter
Recommended type is closed M6 rivet nut, L = 23 mm, code 23351060030 /
Rivkle provided by Böllhoff (www.boellhoff.de).
2. Lift the drive by its lifting lugs and place it into the mounting hole.
3. Fix the washers and screws (M6) delivered with the drive (MRP code 68390419).
The tightening torque is 2 Nm.
Note: The flange mounting kit does not ground the drive. The drive needs to be
grounded according to instructions given in chapter
Note: Maximum allowed vibration for the drive has not been tested with flange
mounting. If the drive is exposed to vibration, it is recommended to fix the drive also
from the normal mounting holes located on the heat sink. See section
procedure.
Mechanical installation
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Dimensional drawings. Screw holes can be replaced with rivet nuts.
Electrical installation.
Installation