Table of Contents
Advertisement
Selecting DMX mode in the Exterior Wash 100 and 110
The DMX control mode may be set from the control panel or by RDM. To set the Exterior Wash 100 or
Exterior Wash 110 DMX mode from the control panel:
1.
Press and hold the MENU button to access the control menu. If prompted for a password, press the
arrow buttons to scroll to the 3-digit password. Press ENTER when the password is displayed.
2.
Use the UP and DOWN buttons to select FIXTURE CONFIG from the menu. Press ENTER.
3.
Select DMX MODE and press ENTER.
4.
The fixture's DMX control mode setting is displayed. To change the mode setting, press the UP or
DOWN button.
5.
Press ENTER to store the DMX mode setting.
6.
Press MENU to exit.
DMX channels in the Exterior Wash 120
The Exterior Wash 120 has one DMX control mode that uses three DMX channels, giving individual
control of warm white LEDs, individual control of cool white LEDs, or overall control of color temperature.
DMX addresses
The Exterior Wash 100 and Exterior Wash 110 use three, four or five DMX channels, depending on the
DMX control mode selected. The Exterior Wash 120 uses three DMX channels. The DMX address, also
known as the start channel, is the first channel used to receive instructions from a DMX controller. If a
fixture that requires four DMX channels has its DMX address set to 1, for example, then it uses channels
1, 2, 3 and 4. The next fixture can have its DMX address set to 5, the next to 9 and so on until the 512
channels in one DMX universe are allocated.
For independent control, each fixture must be assigned its own control channels. Two fixtures of the same
type (and set to the same DMX control mode) may share the same address and control channels if
identical behavior is desired.
The DMX address may be set from the control panel or by RDM. To set the fixture's DMX address from the
control panel:
1.
Press and hold the MENU button to access the control menu. If prompted for a password, press the
arrow buttons to scroll to the 3-digit password. Press ENTER when the password is displayed.
2.
Use the UP and DOWN buttons to select DMX ADDRESS from the menu. Press ENTER.
3.
The fixture's DMX address setting is displayed. Press the UP or DOWN button to scroll to the desired
DMX address.
4.
Press ENTER to store the DMX address setting.
5.
Press MENU to exit.
Programming a standalone show
You can program a standalone show to run without a controller or if DMX control is suddenly lost. The
show can have up to 20 separate effects, or scenes, that display for up to 10 minutes each. Scenes can
be programmed to fade from one scene to the next over a period of 0 to 120 seconds.
Note: To enable standalone operation, the DMX STATE setting in the FIXTURE CONFIG menu must be
set to SHOW MODE. See page Error! Bookmark not defined.. The show will run only when there is no
DMX input.
To program a standalone show:
1.
Access the control menu and select PROGRAM SHOW. Press ENTER.
2.
Set the number of scenes. Select SET SCENE TOTALS and press ENTER. Use the arrow buttons to
select from 1 to 20 scenes. Press ENTER.
3.
To modify scene colors (on 100 and 110 models) or color temperatures (on the 120 model):
a)
Select EDIT SCENE COLOR and press ENTER.
b)
Scroll to a scene to modify and press ENTER.
c)
Select the attribute to change (red / green / blue / white, or warm white / cold white) and press
ENTER.
d)
Press the UP arrow to increase the attribute or the DOWN arrow to decrease it. When satisfied
with the amount, press ENTER.
e)
Repeat steps c) and d) for each attribute.
20
TM
Exterior Wash
100 Series User Manual
Advertisement
Table of Contents
