Installing The Media Converter On A Wall; Figure 19: Marking The Screw Hole Locations - Allied Telesis AT-DMC1000/SC Installation Manual

Installing the Media Converter on a Wall

To install the media converter on a wall, perform the following procedure:
1. Place the media converter on a table.
2. Use a pencil or pen to mark the wall with the locations of the two
anchor holes in the mounting bracket (separately purchased).
It is recommended to orient the bracket horizontally with the cable tie
notches facing either upward or downward. However, if there are
space restrictions, the bracket may also be oriented vertically with the
cable tie notches facing toward either the left or right. Figure 19 shows
an example of a recommended orientation.
Figure 19. Marking the Screw Hole Locations
3. Install two plastic anchors (included with separately purchased
bracket) into the wall, at the locations marked in Step 2.
4. Secure the bracket to the wall using two wall mounting screws
(included with the separately purchased bracket). See Figure 20 on
page 42.
AT-DMC1000/100 Series Desktop Mini Media Converter Installation Guide
Mark locations
41