Gain Switch - Projekt Elektronik FM 302 Operating Manual

6. Operation
The outcome of the given current drive capability is that higher capacitive
loads results in a reduction of bandwidth.
Unloaded the amplifier has a bandwidth of >100 kHz whereby even fast
transient signals can be transferred.

6.6.2.6 Gain Switch

With this switch the gain can be switched between x5 (±2 V → ±10 V) and
x50 (±0.2 V → ±10 V).
6.6.3 Adapter Cable
3 pieces of 1-axis adapter cable are supplied with the AS-Adapter 3. These
cables have a 15-pin SubD socket on one side and four individual wires on
the other side. Thus, with this adapter cables 3 AS-active probes can be
easily connected to the AS-adapter 3. For ease of use, the 3 adapter cables
are assigned according to the channels "X, Y, Z".
The cables can be extended both on the side of the SubD socket with probe
extension cables and on the side of the single conductors.
The assignment of the individual conductors to the respective connection of
the probe or the connection of the AS-probe adapter is shown in Table 2
below.
cabel
X
Y
Z
Projekt Elektronik
MESS - UND REGELUNGSTECHNIK GMBH
wire color probe function
GE +3V
GN -3V
WS probe signal
BR ground
GE +3V
GN -3V
WS probe signal
BR ground
GE +3V
GN -3V
WS probe signal
BR ground
connector
AS-Adapter 3
+3V
-3V
IN X
IN GND
+3V
-3V
IN Y
IN GND
+3V
-3V
IN Z
IN GND
Table 2
Page 79