Table of Contents
Advertisement
6. Operation
− Take the desired probe, connect to Teslameter FM 302 and screw.
− Plug the power adapter into a 230 VAC mains socket.
− Plug the small plug from the power adapter into the 9 V-power connector
at the lower left side of the Teslameter FM 302 (see section 6.3.1.19
Power Connector).
− At the AS-NTP 0,6 probe unscrew and remove the protective cap. At the
AS-NTP-Flex probe and AS-NTP-Hot-05 probe careful draw of the
protective cap.
− Switch the instrument ON with the power switch on the left hand side
(see section 6.3.1.4 Power Switch).
− Set the desired parameters with the keys of the keypad. Especially set
the appropriate measuring range with key "gain" (see section 6.3.1.9 Key
"gain" – Measuring Range and measuring mode DC or AC/RMS with key
"DC AC" (see section 6.3.1.8 Key "DC AC" – Measuring Mode.
− The magnetic field can now be measured with the probe.
6.3.2.5 USB Operation
− Open the case
FM 302.
− Take the desired probe, connect to Teslameter FM 302 and screw.
− Connect the USB port of the Teslameter FM 302 (see section 6.3.1.18
USB Interface) and the USB port of the PC with a USB cord.
− At the AS-NTP 0,6 probe unscrew and remove the protective cap. At the
AS-NTP-Flex probe and AS-NTP-Hot-05 probe careful draw of the
protective cap.
− Switch the instrument ON with the power switch on the left hand side
(see section 6.3.1.4 Power Switch).
− Set the desired parameters with the keys of the keypad or the USB
commands. Especially set the appropriate measuring range with key
"gain" (see section 6.3.1.9 Key "gain" – Measuring Range and measuring
mode DC or AC/RMS with key "DC AC" (see section 6.3.1.8 Key "DC
AC" – Measuring Mode.
− The magnetic field can now be measured with the probe.
Projekt Elektronik
MESS - UND REGELUNGSTECHNIK GMBH
(printed lettering up) and remove the Teslameter
Page 36
Advertisement
Table of Contents
