Table of Contents
Advertisement
5. Description
5.2.4
AS-Adapter 3
The AS-Adapter 3 is used for the autonomous operation of 1-axis and 3-axis
AS active probes. The signals from all 3 probes are available simultaneously
and in parallel via the BNC connections or via the terminal contacts.
The AS-Adapter 3 supplies the AS active probes with ± 3 V in a highly stable
manner. The probe signals are amplified with x5 or x50, so that with ± 2 V or ±
0.2 V they can output ± 10 V for a PLC system and Provide oscilloscope.
The wide supply voltage range is 9 VDC to 36 VDC. The signals and supply of
the probes are galvanic isolated from the operating voltage.
The analog output of the AS-adapter 3 is calibrated and thus can be used
e.g. for displaying magnetic pulses in the µs-range (Oscilloscope), recording
of measurements and for field control. The bandwidth of the analog output
reaches from DC to a least 100 kHz. Therefore it is suitable for measuring
both constant magnetic fields and alternating magnetic fields. The actual
usable bandwidth depends on used AS-active probe.
After connecting the desired probe, the measurement can start without
adjusting zero and scale because all AS-active probes are calibrated. Hence
replacement probes can be used at any time.
All of our AS-active probes may be connected to the AS-Adapter 3. This
allows the fast adaptation to different measuring task by simply plugging in a
different probe. Depending on the type of AS-active probe fields from a few
nano Tesla up to 12 Tesla can be measured. Further information can be
found in the data sheet of the AS-active probes.
The AS-Adapter 3 has table feet's and a DIN rail holder mount for cabinet
device mounting.
Projekt Elektronik
MESS - UND REGELUNGSTECHNIK GMBH
Page 18
Advertisement
Table of Contents
