Table of Contents
Advertisement
6. Operation
6.3.4.6 Logging of Measured Values
The control software not only permits to display the measured values of the
FM 302 but also to save them into a log file. There are two different modes
and two different file formats to chose from. The selection can be made in
the section "logging".
It is always stored one measured value per line with the current time stamp
with 0.1 s resolution, the current measured value and its unit. If one of the
measuring modes relative measurement, maximal measurement or minimal
measurement is active the corresponding mode abbreviation and the
corresponding reference or measured value and its unit is also stored.
Below is printed an extract from a log file as an example. The measured
values are chronological one below the other. The last measured value is at
the lowest line.
Projekt Elektronik
MESS - UND REGELUNGSTECHNIK GMBH
Figure 27 Oscilloscope-like display
Figure 28 Setting logging parameter
Page 53
Advertisement
Table of Contents
