Fixing The Field Controller To A Holder And Pole - Leica GS18 User Manual

Equipment setup
step-by-step
4.1.4
☞
Components of the
GHT66 Holder
Fixing the field con-
troller and GHT66 to
a pole step-by-step
30
a GS instrument with integrated UHF radio modem
b GLS30 carbon fibre pole
c GAT28 radio antenna
d CS20 field controller
e SD card for CS20
f GEB331 battery
g GHT66 holder
h GHT63 pole clamp
i CS35 tablet
j USB stick
k GHT78 holder
l SD card for GS18
m GEB331 battery
1. Attach the GHT66 for CS20 holder to the pole.
2. Insert the data storage device and the battery into the field control-
ler.
3. Clip the field controller into the holder and lock it by pushing the
locking pin into the locked position.
4. Press ON/OFF button on the field controller to switch on.
5. Insert the data storage device and the batteries into the GS18.
6. Press ON/OFF button on the GS18 to switch on.
7. Screw the GS18 to the top of the pole.
8. The field controller and GS18 are connected via Bluetooth.

Fixing the Field Controller to a Holder and Pole

This chapter is valid for all holders.
The GHT66 holder consists of the following components:
a
b
c
0014289_001
☞
For an aluminium pole, fit the
plastic sleeve to the pole clamp.
1. Insert the pole into the clamp
hole.
2. Attach the holder to the clamp
using the clamp bolt.
GHT63 clamp
d
a Plastic sleeve
e
b Pole clamp
c Clamp bolt
GHT66 holder
f
d Locking pin
g
e Top clip
h
f Mounting plate
i
g Bottom clip
h Tightening screw
i Mounting arm
Operation