Leica GS18 User Manual page 21

Button combinations
User Interface
Button
Button
ON/OFF
Function
Function
base mode and a position is available, RTK OUT
•
is configured: The RTK base LED flashes green
for 2 s.
The GS18 takes the next available position and
updates the coordinates of the currently stored
RTK base position.
base mode and no position is available, no RTK
•
OUT is configured: No action.
rover mode: No action.
•
Press and hold button for 5 s.
If the GS18 is in:
base mode: No action.
•
rover mode and RTK IN via Internet is configured:
•
The RTK rover LED flashes green for 2 s. The
GS18 will connect to the RTK base station or the
Ntrip server configured.
• rover mode and RTK IN active and data being
received via Internet: The RTK rover LED flashes
green for 2 s. The GS18 will stop the RTK stream
and disconnect to the RTK base station or (Ntrip)
server.
rover mode but RTK in not configured: No action.
•
Function
Press and hold both buttons, release after 1 s.
The current almanacs stored on the GNSS instrument
are deleted and new almanacs are downloaded. The
Position LED flashes orange quickly three times.
Press and hold buttons for 5 s.
The Memory LED flashes red quickly three times. If
inserted, the SD card of the GNSS instrument is for-
matted. The Memory LED continues to flash red as
the SD card is formatted.
Press and hold buttons for 10 s.
The System RAM on the GNSS instrument is format-
ted. Settings of all installed software will be deleted.
After the formatting the System RAM, the GNSS
instrument is turned off.
Following LEDs flash simultaneously three times:
Position LED: Orange
•
Tilt LED: Red
•
• RTK Base and RTK Rover LEDs: Green
Press and hold buttons for 15 s.
21