Working With The Sd Card; Working With The Tilt Compensation - Leica GS18 User Manual

4.3
☞
☞
Insert a SD card and
micro SIM card step-
by-step
4.4
Description
38

Working with the SD Card

Keep the card dry.
•
Use it only within the specified temperature range.
•
• Do not bend the card.
Protect the card from direct impacts.
•
Failure to follow these instructions could result in data loss and/or permanent
damage to the card.
2a
3
2
0014293_001
☞
Removing the SD card or micro SIM card while the GS18 is turned on
can cause loss of data. Only remove the SD card or micro SIM card or
unplug connecting cables when the GS18 is switched off.
☞
The SD card and micro SIM card are inserted into a slot inside the
battery compartment of the instrument.
1. Push the slide fastener of the battery compartment in the direction
of the arrow with the open-lock symbol.
2. Remove the cover from the battery compartment.
3. Slide the SD card and micro SIM card with the logo facing upwards
firmly into the slot until it clicks into position.
4. Insert the cover of the battery compartment into the compartment.
5. Push the slide fastener in the direction of the arrow with the close-
lock symbol.

Working with the Tilt Compensation

The pole can be held in a slanting position over the point to be measured
without checking the circular bubble on the pole.
Measurements are reliable and accurate even if the pole is not levelled as the
tilt values are calculated by an Inertial Measurement Unit. Tilt values contain
information about the 3D position of the pole.
The measurements are immune to magnetic disturbances as there is no mag-
netometer used.
2b
Operation