Removing The Clamp Brackets; Installing The Clamp Brackets; Adjusting The Trim Sensor - Yamaha F50F Service Manual

Hide thumbs Also See for F50F:
Table of Contents

Advertisement

BRKT

Removing the clamp brackets

1. Remove the power trim and tilt or hydro
tilt. For removal procedure, see "Remov-
ing the power trim and tilt unit/hydro tilt
unit."
2. Loosen the self-locking nuts 1, and then
remove clamp brackets 2 and 3.
3. Remove the trim sensor 4.
2
1

Installing the clamp brackets

1. Install the trim sensor 1 onto the port
clamp bracket.
NOTE:
Adjust the trim sensor after installing the
power trim and tilt.
7-27
Bracket unit
4
3
1
S6C17330
2. Assemble the clamp brackets and the
swivel bracket by installing the self-lock-
ing nuts 2, then tightening them to the
specified torque.
2
A A
Self-locking nut 2:
22 N·m (2.2 kgf·m, 16.2 ft·lb)
3. Install the power trim and tilt or hydro tilt.
For installation procedure, see "Installing
the power trim and tilt unit/hydro unit."
4. Inject grease into both grease nipples
until grease comes out from the bushings
a.
A A

Adjusting the trim sensor

1. Fully tilt the outboard motor up, and then
support it with the tilt stop lever 1.
A A
2
S6C17350
a
S6C17360
6C13G11

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ft50gF60cFt60d

Table of Contents