Omron NA5-15*101 series Startup Manual page 28

1 System Configurations and Startup Procedures
1-1 Startup Procedures
This guide describes the startup procedures for an NA-series Programmable Terminal, from creating
the HMI application to debugging.
Refer to programming examples given in the NJ-series Machine Automation Controller Startup Guide
(CPU Unit) (W513) for information on the Controller connected to the HMI.
The procedures from creating the HMI application to debugging can be performed with the following
system configurations.
System configuration
• Sysmac Studio only
• Sysmac Studio
• NA-series Programma-
ble Terminal
• CPU Unit
The startup procedures for each system configuration are given in the following figure.
Preparations
Creating the
HMI application
Debugging
1 - 2
Operations
Offline debugging
Online debugging
Offline Debugging
Sysmac Studio
3-1 Installing the Sysmac Studio
4-2 Creating a New Project
4-3 Creating the HMI Application
4-6 Making the Initial HMI Settings
The HMI application and user program for the Controller are
created with the Sysmac Studio.
The operation of a virtual HMI and NJ-series CPU Unit is
simulated on the Sysmac Studio to debug the HMI applica-
tion.
The HMI application and user program for the Controller are
created with the Sysmac Studio.
The HMI application is debugged on the actual HMI and
NJ-series CPU Unit.
Online Debugging
Sysmac Studio
NA-series Programmable Terminal
CPU Unit
3-2 Assembling the Hardware
NA-series Programmable Terminal Startup Guide (V120)