Table of Contents
Advertisement
Mechanical installation
Mounting
A – Snap on
1. Choose the location for the module. Note the following:
• The cabling instructions in chapter
• The ambient conditions should be taken into account (see chapter
Technical
2. Switch off all dangerous voltages in the enclosure that the module is to be
mounted in.
3. Fasten the rail.
4. Push the module onto the rail as shown in figure A above. The module can be
released by pulling the locking spring with a screwdriver (see figure B above).
specifications). The degree of protection of the module is IP20.
B – Snap off
Electrical installation
must be followed.
Appendix A:
Mechanical installation
23
Advertisement
Table of Contents
