Table of Contents
Advertisement
42
Alarm monitoring application
In addition to the settings described above in the section
settings for all
SREA-01 for sending alarm messages:
1. Modem settings for sending SMS messages (Setup – Modem)
If you want to send alarm messages by SMS, you have to configure the GSM
modem on the page Setup – Modem. Most important settings:
• Modem type: Select GSM or GPRS to be able to send SMS messages
• Pin code
For more information, refer to section
2. E-mail settings for sending E-mail alarm messages (Setup – Email)
If needed, the E-mail settings are used to define which SMTP server SREA-01
should use when sending alarm messages by E-mail. The E-mail settings can be
changed by selecting the page Setup – E-mail. For more information on the E-mail
settings, refer to the manual section
3. SMS and E-mail recipients (Setup – Users)
If alarm messages are to be sent by SMS or E-mail, you have to configure the
message recipients on the page Setup – Users. Create a user account for each
recipient, enter an E-mail address or a mobile phone number and select the alarm
classes that you want the user to receive messages from. See section
page
4. Device specific default alarms (Configuration – Devices – the drive)
By default, there are three alarms defined for each drive. These alarms are sent
when the drive is disconnected from SREA-01 and when the drive is in fault or
warning state. To enable or disable these alarms or assign them to an alarm class
different from 1, go to the page Configuration – Devices and select the drive you
want to configure. For more information, refer to section
5. Custom alarm configuration (Configuration – Alarms)
If you want to create custom alarms in addition to the default pre-defined alarms, you
can do it on the page Configuration – Alarms. Refer to section
more information.
GPRS access interface application
In addition to the settings described above in the section
settings for all
SREA-01 for accessing the drives remotely over a GPRS connection:
1. User accounts (Setup – Users)
It is recommended to create additional user accounts with fewer privileges for
remote use. More user accounts can be created on the page Setup – Users. Refer to
section
Setting up SREA-01 for typical applications
applications, you should check these settings if you are using
84
for more information.
applications, you should check these settings if you are using
Users
on page
61
Modem
on page 66.
E-Mail
on page 70.
for more information.
Most important common
Alarm
Devices
on page 78.
Alarm
on page
Most important common
on
84
for
Advertisement
Table of Contents
