Introduction - DCS CS-366 Installation Manual

The DCS Professional CS Cooktops feature a large number of features varying with each model. Aii
models feature a minimum of 4 surface burners, with the option of up to 6 surface burners on all
models. Ail of the 48" and 36" Cooktops feature the possibility of various grill and griddle
combinations. Aii cooktop models require the installation of one of the two offered backguards, if
installed with less than 12"to combustible materhL See page 10.
IMPORTANT INSTALLATION INFORMATION
The cooktops are tested in accordance with ANSi Z21.1 Standard for Househoid Cooking Gas
Appihnces. These cooktops must be installed in conjunction with a suitabie overhead vent hood. (See
Step 2 for ventilation requirements). Due to the professionai high heat capacity of this unit, particuhr
attention shouid be paid to the hood and duct work installation to ensure it meets local building
codes. To eliminate risk of burns or fire by reaching over heated surface units, cabinet storage located
above the surface units should be avoided. Check local building codes for the proper method of
cooktop installation. Local codes vary. Instalhtion,electrical connections, and grounding must comply
with all applicable codes. In the absence of local codes, the cooktop should be installed accordance
with the National Fuel Gas Code ANSI Z223.1-1988 and National Electrical Code ANSI/NFPA 70-1990.
Be sure that the unit being installed is set up for the kind of gas being used. The gas cooktop is shipped
from the factory set and adjusted for natural gas or LP (propane), depending on the specific model
ordered. Verify that the cooktop is compatible with gas supply at the installation site before
proceeding further_ Return cooktop to dealer if unit is not set for site gas supply.