Test And Adjustments - DCS CS-366 Installation Manual

TEST AND ADJUSTMENTS
STEP 7:
CAUTION:
For warranty coverage, DC5 requires that burner adjustments be made by a
quafified technician at the time of instaflation. Extreme care should be used
when adjustments are made after installation° Improper or tack of
adjustments will void your warranty°
ABR SHUTTER ADJUSTMENT
(Griddle or Grill only)
Check for the proper burner flame character-
istics and adjust air shutters if necessary
(fig. 10). Each air shutter is individually tested
and adjusted prior to shipment. Normally
adjustment is not required, however,
vibration during transit, or variations in the
local gas supply may make minor
adjustments necessary. Burner flames
should be blue and stable with no yellow
tips, excessive noise or lifting of the flame
from the burner. If any of these conditions
exist, check that the air shutter or burner
ports are not blocked. If this condition
persists, adjust the air shutter as required. If
the flame is too yellow, indicating insufficient
air, adjust the shutter counterclockwise to
increase air inlet, ffthe flame is noisy or tends
to lift away from the burner, indicating too much
air, turn the shutter clockwise to reduce air.
The griddle flames should be lq/2" to 2".
The grill burner flames should be 3/8" to 5/8" (fig. 10).
Typical Section of Proper Flame
Griddle Grill
Fig. 10
SURFACE BURNERS
The surface burners are not adjustable. Proper operation is achieved when the correct orifices for gas
supply are installed at the factory, based on mode[ ordered.
I If the surface burner does not ignite, check the spark igniter by listening for a clicking sound. If you
do not hear the igniter dick, turn off the burner. Check for a tripped circuit breaker, blown fuse, or
poor wire connection to the igniter.
TO CLEAN EXTERIOR SURFACES
The stainless steel surfaces may be cleaned by wiping with a damp soapy cloth. Any mild glass cleaner
wi[[ remove fingerprints and smears. Do not use steel woo[ as it wi[[ scratch this surface. Small
scratches may be removed by lightly sanding with the grain using 120 grit paper.
14