Appendix; Danfoss A/S © 11/2015 All Rights Reserved - Danfoss VLT DriveMotor FCP 106 Operating Instructions Manual

Appendix

8 Appendix
8.1 Abbreviations and Conventions
Degree of
protection
DIx
EMC
Error
Factory
setting
Fault
Fault reset
8 8
MM
MMP
Parameter
PELV
PLC
RS485
Warning
Table 8.1 Abbreviations
Conventions
•
Numbered lists indicate procedures.
•
Bullet lists indicate other information and
description of illustrations.
•
Italicised text indicates:
-
-
-
-
-
-
•
All dimensions are in mm (inch).
54
The degree of protection is a standardised
specification for electrical equipment that
describes the protection against the ingress of
foreign objects and water (for example: IP20).
DI1: Digital input 1.
DI2: Digital input 2.
Electromagnetic compatibility.
Discrepancy between a computed, observed, or
measured value or condition, and the specified
or theoretically correct value or condition.
Factory settings when the product is shipped.
An error can cause a fault state.
A function used to restore the frequency
converter to an operational state after a detected
error is cleared by removing the cause of the
error. The error is then no longer active.
Memory module.
Memory module programmer.
Device data and values that can be read and set
(to a certain extent).
Protective extra low voltage, low voltage with
isolation. For more information, see IEC
60364-4-41 or IEC 60204-1.
Programmable logic controller.
Fieldbus interface as per EIA-422/485 bus
description, which enables serial data
transmission with multiple devices.
If the term is used outside the context of safety
instructions, a warning alerts to a potential
problem that a monitoring function detected. A
warning is not an error and does not cause a
transition of the operating state.
Cross-reference.
Link.
Footnote.
Parameter name.
Parameter group name.
Parameter option.
Danfoss A/S © 11/2015 All rights reserved.
VLT® DriveMotor FCP 106/FCM 106
8.2 Parameter Menu Structure
MG03L302