Dual-Stream Protocol - Yealink VC110 Administrator's Manual

Administrator's Guide for Yealink VC110 Video Conferencing Endpoint
Press the Save soft key to accept the change.
3.
The display device prompts "Reboot now?".
Select OK to reboot the endpoint immediately.
4.

Dual-Stream Protocol

To enhance the process of communicating with others over video, the dual-stream protocol
provides the ability to share content from a computer, such as video clips or documentation.
Both the video and the documentation can be transmitted to the far site simultaneously, thus
meeting the requirements of different conference scenarios, such as training or medical
consultation.
The Yealink video conferencing endpoint supports the standard H.239 protocol and BFCP
(Binary Floor Control Protocol). H.239 protocol is used when sharing content with the far site in
H.323 calls. BFCP protocol is used when sharing content with the far site in SIP calls. Before
enabling the desired protocol, ensure that the protocol is supported and enabled by the far site
you wish to call. If the far site does not support the protocol for sharing content, MCU will
automatically mix the content and camera video, and send them in one channel. For more
information on mix sending, refer to
Dual-stream protocol parameters on the endpoint are described below.
Parameter
H.239
BFCP
To configure H.239 dual-stream protocol for StarLeaf Cloud platform via web user
interface:
Click on Account->VC Platform.
1.
200
Mix Sending
Description
Enables or disables the H.239 protocol for
sharing content. You can configure it for the
StarLeaf Cloud platform or H.323 call
separately.
Default: Enabled
Enables or disables the BFCP protocol for
sharing content. You can configure it for
Zoom/Pexip/BlueJeans/Mind/Custom platform,
SIP account or SIP IP call separately.
Default:
For Zoom/Pexip/BlueJeans/Mind/Custom
platform and SIP IP call, the default value is
Enabled.
For SIP account, the default value is Disabled.
Note: You cannot configure it for the
Yealink/StarLeaf Cloud platform.
on page 205.
Configuration Method
Web User Interface
Web User Interface