Dhcp Vlan - Yealink VC110 Administrator's Manual

In the VLAN block, select the desired value from the pull-down list of Internet Port
2.
Active.
Enter the VLAN ID in the VID (1-4094) field.
3.
Select the desired value (0-7) from the pull-down list of Priority.
4.
Click Confirm to accept the change.
5.
A dialog box pops up to prompt that the settings will take effect after a reboot.
Click OK to reboot the phone.
6.
To configure VLAN via the remote control:
Select Menu->Advanced (default password: 0000) ->Advanced Network.
1.
In the VLAN block, check the Active checkbox.
2.
Enter the VLAN ID in the VID(1-4094) field.
3.
Enter the priority value (0-7) in the Priority field.
4.
Press the Save soft key to accept the change.
5.
The display device prompts "Reboot now?".
Select OK to reboot the endpoint immediately.
6.

DHCP VLAN

The endpoint supports VLAN discovery via DHCP. When the VLAN Discovery method is set to
DHCP, the endpoint will examine the DHCP option for a valid VLAN ID. The predefined option
132 is used to supply the VLAN ID by default. You can customize the DHCP option used to
request the VLAN ID.
Configuring Network
75