Manual Configuration For Vlan - Yealink VC110 Administrator's Manual

Administrator's Guide for Yealink VC110 Video Conferencing Endpoint
To configure LLDP via the remote control:
Select Menu->Advanced (default password: 0000) ->Advanced Network.
1.
In the LLDP block, check the Active checkbox.
2.
Enter the desired value in the Packet Interval (1-3600s) field.
3.
Press the Save soft key to accept the change.
4.
The display device prompts "Reboot now?".
Select OK to reboot the endpoint immediately.
5.

Manual Configuration for VLAN

VLAN is disabled on endpoints by default. You can configure VLAN manually. Before configuring
VLAN on the endpoints, you need to obtain the VLAN ID from your network administrator.
Parameters of manual VLAN on the endpoint are described below.
Parameter
Internet
Port->Active
VID(1-4094)
Priority
To configure VLAN for Internet port via web user interface:
Click on Network->Advanced.
1.
74
Description
Enables or disables VLAN for the
Internet (WAN) port.
Default: Disabled
Note: If you change this parameter,
the endpoint will reboot to make the
change take effect.
Configures VLAN ID for the Internet
(WAN) port.
Default: 1
Note: If you change this parameter,
the endpoint will reboot to make the
change take effect.
Configures VLAN priority for the
Internet (WAN) port.
Valid values: 0-7
7 is the highest priority, 0 is the
lowest priority.
Default: 0
Note: If you change this parameter,
the endpoint will reboot to make the
change take effect.
Configuration Method
Remote Control
Web User Interface
Remote Control
Web User Interface
Remote Control
Web User Interface