Configuring Content Sharing; Configuring Dual-Stream Protocol; Configuring The H.239 Protocol - Yealink VS800 Administrator's Manual

• LAN Connection: Make sure the Yealink video conferencing system and the control system are in the same
network segment. If you use this mode to control the system, TCP protocol is recommended. To establish a
connection, the control system needs to know the IP address and TCP port of the Yealink video conferencing
system.
Serial Connection: The USB port on the Yealink video conferencing system can be connected to the serial port on
•
the control system through a USB to RS-232 cable.
For more information, refer to
Introduction for Yealink Video Conferencing

Configuring Content Sharing

You can select dual-stream protocol or mix sending method to share content, and you can configure the mode, the
frame rate and the resolution for the shared content.
Note:
If the far site does not support the dual-stream protocol, you can select the Mix Sending feature to mix the
video and content, and then send them to the far site in one stream.
•

Configuring Dual-Stream Protocol

• Configuring Mix-Sending
• Configuring Content Sharing
Configuring Dual-Stream Protocol
The dual-stream protocol allows the video and PC content to be transmitted to the far site simultaneously, thus
meeting the requirements of different conference scenarios, such as training or medical consultation. Based on this
protocol, the participants can share contents while having a video call.
The Yealink video conferencing system supports the standard H.239 protocol and BFCP (Binary Floor Control
Protocol).
•

Configuring the H.239 protocol

• Configuring BFCP (Binary Floor Control Protocol)
Configuring the H.239 protocol
H.239 protocol is used when sharing content with the far site in H.323 calls.
Procedure
1. Do one of the following:
• On your web user interface, go to Account > VC Platform > Video Conference Platform > Platform
Type > StarLeaf.
• On your web user interface, go to Account > H.323.
2. Configure and save the following settings:
Parameter
H.239
Yealink VC Deployment and User Manual for Control Systems
System.
Description
Enable or disable the H.239
protocol.
Default: On.
| Configuring Content Sharing | 143
and API Commands
Configuration Method
Web user interface