Page 1
Yealink Network Technology CO., LTD Yealink VC120 Video Conferencing System Quick Start Guide V22.15 Applies to firmware version 40.22.0.15 or later...
Table of Contents Packaging Contents VC120 Connections Remote Control and Cable Ties Installation Bracket and Camera Installation Main Screen Network Deployment Troubleshooting...
Video Conferencing Phone Package Please use the Yealink-customized DVI cable. We recommend that you use the accessories provided or approved by Yealink. The use of unapproved third-party accessories may result in reduced performance. VC120 video conferencing system can work with the video conferencing phone or video conferencing microphone...
VC120 Connections The video conferencing phone is used to be the audio input/output device: Display HDMI-VGA Direct Cable HDMI Cable 2m Ethernet Cable Power Adapter 7.5m Ethernet Cable DVI Cable Camera CPE80 CPE80 Video Conferencing Phone...
Page 5
VCM30 Camera Please connect to the Display1 port if you only have one display device The system should be used with Yealink original power adapter (19V/3.42A) only. The use of the third-party power adaptermay cause the damage to the system...
Bracket and Camera Installation Hanging Mode Please chose the following installation mode when the thickness of the TV is between 35-120mm Steps: Lock the camera to the L-bracket. Remove the protection of the Velcro. Put the L-bracket on the top of the TV. Make sure the back of the TV is clean, and then adjust the bracket to ensure close adhesion to the back of the TV with Velcro.
Page 8
Wall Mount Method Screw specification: M3 8 100mm Hole depth: 30mm Screw specification: T4 30 Hole diameter: 6mm Steps: Punch holes & Insert expansion bolts Drive screws Adjust the screws position and manually lock them Insert screws to lock the bracket to the wall Connect DVI cable Lock the camera The recommended height for camera positioning is 1.5m-1.8m above the ground...
With Cloud service, organizations can communicate using the Cloud platform, so that complex network settings are unnecessary. Both the head office and the branch offices can use this deployment method. You can log into Yealink Cloud/StarLeaf/Zoom/Pexip/BlueJeans/Mind/Custom platform using VC120 video conferencing system. Get account information from your administrator.
Page 11
Head Office If you deploy VC120 in the head office, at least one static public IP address is required in the head office to allow branch offices to connect. Do one of the following to deploy VC120: Option1: To deploy the VC120 on a public network, at least one static public IP address is required, you need to assign a static public IP address to the VC120.
Page 12
Configure Port Mapping If the VC120 is deployed in an Intranet, and you want to solve the interconnection problem by port mapping, you must forward the following ports to the public network on the firewall. Function...
Page 13
Branch Office If you delpoy VC120 in the branch office, do one of the following to deploy it: Option1: Deploy the VC120 following the same steps as for the head office. In this way, both inbound and outbound calls are available.
Troubleshooting After installation and deployment, you can test the VC120 by dialing the Yealink Demo Room. If you can’t dial out successfully, please contact your IT administrator to check the internal network configuration.
Page 15
Select Auto from the Type pull-down list, the system will obtain public IP address automatically. If the system does not obtain a public IP address automatically, select Manual Settings from the Type pull-down list, and then enter the public IP address in the Public IP Address field. Yealink Test Room IP: 117.28.251.50、117.28.251.51...
Need help?
Do you have a question about the VC120 and is the answer not in the manual?
Questions and answers