Specifications - Rinnai RIB2312L Operation & Installation Manual

Model
Model Name
Features
Data Plate
Input
Output (High)
Injectors
Efficiency
Heating Area
Note: * Will vary according to gas type and flue configuration ** Will vary depending on geographical location
Installation Types
Combustion Method
Flue - Masonry (if required)
Flue - Freestanding & Zero Clearance
Convection Fan
Gas connection
Gas type
Electrical
Ignition
Power Consumption
Safety Devices
Flame Settings
Glass - Primary
Glass - Secondary
Glass seal material
Weight (Engine Only)
Operation
Noise Level
Refer to appliance data plate for Gas Type, Gas Rates, Injector Sizes and Burner Pressures.
NOTE
Rinnai

SPECIFICATIONS

RIB2312
Sapphire Gas Log Flame Fire
Inbuilt or Freestanding Gas Space Heater
Burning log effect
Glass front
Convection Fan, top warm air outlet
Glass dress guard (standard model)
Mesh dress guard (classic model)
Located on the lower RHS of the base panel in front of the gas control.
14 - 30 MJ/h
*6.7 kW
Refer to the data plate on the appliance
80% (on high)
**95 m2 (Cool Climate Zone)
Inbuilt Masonry, Inbuilt Zero Clearance and Freestanding options
Bunsen type burner
FlexiLiner diameter. 100 mm
Twin skinned diameter. 100mm x diameter. 150mm outer
Double drum. 160mm x 180mm - 2 speed - Centrifugal
1/2" BSPT Male brass fitting
NG, Propane Universal LPG
The heater engine is fitted with a 1.5 m power cord and three pin plug
which exits the appliance from the rear panel at the lower left
230 Volt AC 50 Hz high voltage electronic spark ignition
Less than 50W Normal Operation. Less than 3W on Standby
1500 mm cord is supplied with a 3 pin plug
Overheat Switch
Electrical Fuse
Flame Failure Sensing System (FFD)
Power Failure Protection
Gas Lock-out (1 minute after attempted restart)
Five different flame settings
Ceramic Glass
Tempered Glass
Woven fibreglass chord - Hytex® 1000 by mid Mountain USA
60 Kg - "uncrated" - no Flue
Push button control panel Infra Red Control
37 - 45 dB(A)
19
SAPPHIRE RIB2312 OIM