Table of Contents
Advertisement
After this operation, we can start work from the second file not forgetting about the measurement
after tool change („Auto Tool Zero" button).
When the file is loaded, and the tool is measured we can set the axes again over the material with
the MDI like before.
Press „Cycle Start" and start the treatment.
C S - L a b s . c . – C S M I O / I P - S - C N C C o n t r o l l e r
Page 86
Advertisement
Table of Contents
Need help?
Do you have a question about the CSMIO IP-S and is the answer not in the manual?
Questions and answers