Qbx Series - ISHIDA NOVA-II Setup Manual

2.7

QBX Series

Follow the steps below to set up and calibrate the QBX Series scale.
Setup
1 Press and hold the MODE key until [Func] –> [CAL] appear in sequence, then release the key.
2 Press and hold the T key, press the MODE key, then release both keys at the same time.
3 [un it] appears. Press the T key to increase the value of the right digit in this order:
[1] –> [2] –>. . . . [5]
Select the desired until system number (see table below).
4 Press the MODE key to call up [on 0]. The QB automatically performs zero adjustment.
(Do not leave any weight on the pan).
5 After the QBX performs zero adjustment, [on FS] is shown. Place the calibration weight on the center of the
weigh pan (see table below for designated calibration weights).
6 When calibration is complete, the scale automatically returns to weighing mode.
NOTES:
• Press any key to cancel calibration procedures and return to the weigh display.
• If appears on the display, the weight exceeds the scale capacity.
[o–Err]
• Standard calibration weight is
weight. See the table below for the unit system capacities.
• If appears on the display, the calibration weight is less than 50% of the standard.
[1–Err]
• If [2–Err] appears on the display, an object other than the calibration weight is on the pan, or the display
tolerance (1%) is exceeded.
Unit No. (mark) QB–150E QB–300E QB–600E QB–1500E QB–3000E QB–6000E QB–12KE QB–620E QB–6200E
1 (g) 150
2 (kg) 0.15
3 (ct) 750
4 (oz) 5.2
5 (lb) 0.33
14 Ishida Setup & Calibration Manual
capacity. However, when possible, calibrate using a full capacity
1/2
300 600 1500
0.3 0.6 1.5
1500 3000 7500
10 21 52
0.66 1.3 3.3
Action
3000 6000 12000
3 12
15000 30000 60000
100 210 420
6.6 13
620 6200
12 0.62 6.2
3100 31000
21 210
26 1.3 13