Mtx/Mtb - ISHIDA NOVA-II Setup Manual

2.1

MTX/MTB

The MTX and MTB Series scales have the same configuration and setup procedures.
NOTE:
Configuration settings must be set before calibrating the MTX/MTB series scales.
2.1.1 Configuration
Models Cn
MTX-300L F
MTX-60L F
MTB-300L F
MTB-60L F
MTX-150Kg F
MTX-30Kg F
MTB-150Kg F
MTB-30Kg F
To Access The Configuration Settings:
1. Turn off the scale.
2. Press and hold the
3. Press and release the
NOTE
: For the MTB, press and hold the
4. Release the ZERO
To Enter Data:
1. The table above shows the parameter settings for the MTX/MTB series models. Use the
(–) keys to select the corresponding settings for each parameter (Cn–C8).
TARE
2. Use the
COUNT
To Review:
1. After the operator enters C8 (see table above), the input displays C4–C1 setting.
2. If the C4–C1 settings are not correct, turn the scale off, then on again and re-enter the settings.
If the C4–C1 settings are correct, press the
3. The unit displays the C8-C5 settings.
4. If the C8–C5 settings are not correct, turn the scale off, then on again and re-enter the settings.
If the C8–C5 settings are correct, press the
Calibration
Continue with normal calibration as described on page7, Section 2.1.2 beginning from Step 3 (display =
CA–).
6 Ishida Setup & Calibration Manual
C1 C2 C3 C4
1 F 6 b
6 F 6 b
1 E 6 b
6 E 6 b
A F 6 b
2 F 6 b
A E 6 b
2 E 6 b
and keys.
ZERO COUNT
ON/OFF key.
ON/OFF
key for at least 2 seconds.
and COUNT keys.
key to enter the data and advance to the next step.
Parameter
C5 C6 C7 C8
9 2 2 0
9 2 2 0
9 2 2 0
9 2 2 0
9 2 0 0
9 2 0 0
9 2 0 0
9 2 0 0
key.
COUNT
key.
COUNT
Check 1 Check 2
B6F1 0229
B6F6 0229
B6E1 0229
B6E6 0229
B6FA 0229
B6F2 0229
B6EA 0229
B6E2 0229
(+) and
ZERO