Table of Contents
Advertisement
Replacing the Memory Module on RAID Systems
The RAID controller comes with pre-installed DRAM module(s). You may upgrade it
or replace it when the original module malfunctions (shown as the "NVRAM failure"
event in SANWatch).
WARNING
If you are installing only one or replacing just one DRAM module, with the I/O ports
pointing at you, always install to the DRAM slot on the right (blue slot).
Follow the ESD Precautions (refer to
Contact your system vendor for selecting a compatible DRAM module.
Reusing the DRAM module removed from a failed controller is not recommended
unless you have a similar RAID system to test its integrity.
Installing the DIMM Module
1. Remove the controller module (refer to
2. Wait for one minute for the remaining electricity on the main board to disperse.
3. Push down the clips on the sides of the DIMM socket (indicated by the
circle). The DIMM will eject automatically from the socket.
ESD
Precautions).
Replacing the Controller
115
Module).
blue
Advertisement
Table of Contents
