Installing The Hard Drive Into Drive Tray - Infortrend EonStor DS 1024B Hardware Manual

Installing the Hard Drive into Drive Tray

Open the bezel by pressing the release button and gently pull out the tray.
Place the hard drive into the drive tray, making sure that the interface connector is
facing the open side of the drive tray and its label side facing up.
If you have a MUX board and you want to install a SAS drive, the MUX board should
be removed.
Installing a 3.5" SAS HDD or single controller systems
Installing a 3.5" HDD with a MUX Board (SATA drives)
Adjust the drive location until the mounting holes in the drive tray are aligned with
those on the hard drive. Secure the drive with four of the supplied flat-head screws.
2.5 inch SAS hard drive
2.5 inch SATA hard drive
37