Replacing the fuse
➨ Switch off the pump.
➨ Disconnect the electrical power cord before opening
+ Identify and eliminate the cause of failure before switch-
➨ Keep the snap-fit squeezed and pull the fuse holder out.
➨ The fuse holder contains two fuses of the same type. Replace the de-
fective fuse with a fuse of the same type (see "Technical data")
➨ Insert the fuse holder into the housing of the pumping unit until it snaps
into place.
page 66 of 76
the terminal box. After disconnecting from power, wait
5 seconds to allow the capacitors to discharge.
ing on the equipment again.
fuse holder