Replacing Diaphragms And Valves - vacuubrand BVC control Instruction Manual

Replacing diaphragms and valves

➨ Never operate the pump if covers or other parts of the
➨ Before starting maintenance, disconnect the electri-
➨ Ensure that the pump cannot be operated accidentally.
➨ Note: The pump might be contaminated with the pro-
➨ Avoid the release of pollutants.
+ Never operate a defective or damaged pump.
+ Take adequate precautions to protect people from the
+ Check every motor capacitor regularly by measuring its
+ Allow sufficient cooling of the pump before starting
+ Vent the pump and isolate it from the vacuum sys-
page 57 of 76
pump are disassembled.
cal power cord. Wait 5 seconds after isolating the
equipment from AC power to allow the capacitors to
discharge.
cess chemicals that have been pumped during opera-
tion. Ensure that the pump is decontaminated before
maintenance.
effects of dangerous substances that may have con-
taminated the pump and may be released upon dis-
assembly. Ensure that the maintenance technician is
familiar with the safety procedures which relate to the
products processed by the pumping system.
Use appropriate protective clothing, safety goggles and
protective gloves.
capacity and estimating its service life. Replace old ca-
pacitors early enough to prevent a failure. The capaci-
tors must be replaced by a trained electrician.
maintenance.
tem before you start maintenance.