Restarting The Unit - TANDBERG TT1260 Reference Manual

3.12

Restarting the Unit

The System Restart submenu allows the user to reboot the unit without having to remove and
insert the power cable.
Table 3.30: System Restart Menu
Step
1
2
3
3.13 Setting Up a Preset Service
Follow the steps in the table below to store the current Service as a preset.
Table 3.31: Setting up a Preset Service
Step
1
2
3
4
NOTE...
It is not possible to store a service to a preset unless that service is being received (including all the
required components such as video, audio, data, VBI, etc).
Reference Guide: TT1260 Contribution Receiver
ST.RE.E10100.3
Action
Go to Menu 6.3.
Press Edit.
Press Save to activate.
Action
Use the menus to set up the unit so that the
required Service is current.
(Refer to Sections 3.5 and 3.6)
Go to Menu 1 to view the Preset menu.
Select a location to store the preset.
The EDIT mode cannot be entered unless a
valid Service being decoded.
Press Save.
Operating the Equipment Locally
Result
Accesses the System Restart menu.
ACTIVATE will be displayed.
Unit is restarted. User prompted with 'Are you sure?
Continue/Cancel'.
Result
This selects the Service and associated parameters for the preset
process.
This displays the menu which allows the Current Service to be
stored at a chosen location (01 – 40). If there is no Current
Service, the menu display reads NO STORED SERVICE.
Use Edit and the arrow pushbuttons to step through the stored
items. This allows a specific location to be chosen. Any vacant
locations are marked by NO STORED SERVICE.
This stores the current Service and its associated parameters as
a preset in the selected location. This adds the Service to the list
displayed on page 1.
Page 3-23