10/100Baset Ip (Tt1260/Hwo/Ip); Telco Receiver - Ds3/E3 (Tt1260/Hwo/Atm-Ds3, Tt1260/Hwo/Atm-E3) - TANDBERG TT1260 Reference Manual

10/100BaseT IP (TT1260/HWO/IP)

Table 3.11 steps through the set up procedure of the Telco Receiver using
Menu 2 Input, and the IP input.
Table 3.11: Setting Up the IP interface
Step Action
1 Connect the Ethernet cable to the IP input connector.
2 Power up the unit and navigate to Menu 2 Input.
3 Navigate to UDP PORT (Menu 2.2), then press Edit
Select the Receive UDP Port number, then press Save.
4 Navigate to IP INPUT IP ADDRESS (Menu 2.2.1), then press Edit
Select the IP address, then press Save.
5 Navigate to IP INPUT SUBNET MASK (Menu 2.2.2), then press Edit.
Select the Subnet mask, then press Save.
6 Navigate to IP INPUT GATEWAY ADDRESS (Menu 2.2.3), then press Edit.
Select the Gateway address, then press Save.
7 Navigate to IP INPUT MULTICAST IP ADD (Menu 2.2.4), then press Edit.
Select the Multicast IP address, then press Save.
8 Return to Input Menu 2, it should display the current status. If status is NOT LOCKED, verify that the cable is
properly connected and that all values have been entered correctly.
Telco Receiver – DS3/E3
(TT1260/HWO/ATM-DS3, TT1260/HWO/ATM-E3)
Table 3.12 steps through the set up procedure of the Telco Receiver using
Menu 2 Input, and the DS3 or E3 input.
Table 3.12: Setting Up the DS3/E3 interface
Step Action
1 Connect the cable to the DS3/E3 input.
2 Power up the unit and navigate to Menu 2
Input.
3 Press the Right pushbutton then navigate to
Menu 2.2, Input Set up, then press Edit.
Set the required parameters, then press Save.
4. Press the Right pushbutton to access Menu
2.2.1 then press Edit.
Select Enable or Disable, then press Save.
Press the Down pushbutton to access Menu
5
2.2.2 then press Edit.
Set the required parameter, then press Save.
6 Return to Input Menu 2, it should display the
current status. If status is NOT LOCKED,
verify that the cable is properly connected and
that all values have been entered correctly.
Reference Guide: TT1260 Contribution Receiver
ST.RE.E10100.3
Operating the Equipment Locally
Result
Accesses the Input menu.
Sets the VPI, VCI and Enable/Disable the Payload Descrambling.
Enable/Disable the Cell Discard and HEC Correction.
Set the required Packet Length.
Page 3-11