Atm Receiver; Ttv G.703 (Tt1260/Hwo/G703) - TANDBERG TT1260 Reference Manual

Operating the Equipment Locally
Table 3.9: Tuning the Terrestrial Receiver
Step Action
1 Connect the cable to the COFDM input.
2 Power up the unit and navigate to Menu 2 Input.
3 Press the Right pushbutton to access Menu 2.1
4 Press the Down pushbutton to access Menu 2.2, then press Edit
5 Use the Up and Down pushbuttons to select RF input, then press Save.
6 Navigate to AUTO DETECT (Menu 2.2.4), then press Edit.
Select ENABLE, then press Save.
7 Navigate to FREQUENCY (Menu 2.3), then press Edit.
Enter the desired Satellite frequency in MHz, then press Save.
8 Navigate to CHANNEL SPACE (Menu 2.3.2), then press Edit.
Select the desired channel space (6, 7, 8 MHz), then press Save.
9 Navigate to HIERARCHY STREAM (Menu 2.4), then press Edit.
Enter the desired hierarchy stream, then press Save.
10 Return to Input Menu 2, it should display the current status. If status is NOT LOCKED, verify that the cable is
properly connected and that all values have been entered correctly.
3.6.3

ATM Receiver

TTV G.703 (TT1260/HWO/G703)

Table 3.10 steps through the set up procedure of the ATM Receiver using
Menu 2 Input, and the TTV G.703 input.
Table 3.10: Setting Up the TTV G.703 interface
Step Action
1 Connect the cable to the TTV G.703 input.
2 Power up the unit and navigate to Menu 2 Input.
3 Press the Right pushbutton to access Menu 2.2
4 Navigate to INTERLEAVER (Menu 2.2.1), then press Edit
Select Enable or Disable, then press Save.
5 Navigate to SIGNAL LEVEL (Menu 2.2.2), then press Edit
Select Normal or Low, then press Save.
6 Navigate to AUTO DETECT (Menu 2.2.4), then press Edit.
Select ENABLE, then press Save.
7 Return to Input Menu 2, it should display the current status. If status is NOT LOCKED, verify that the cable is
properly connected and that all values have been entered correctly.
Page 3-10 Reference Guide: TT1260 Contribution Receiver
ST.RE.E10100.3