List Of Contents - TANDBERG TT1260 Reference Manual

List of Contents

Chapter 1: Introduction
This chapter identifies the equipment versions covered by this manual; describes the purpose
of the equipment in a typical system; provides a summary of its main features; identifies the
controls, indicators and connectors in a guided tour of the front and rear panels; and lists the
available options.
Chapter 2: Installing the Equipment
This chapter provides a guide to the suitability of an installation; gives detailed procedures for
the preparation, installation and configuration of the equipment including important safety
information; provides pin-out details of the external connectors; and details the power-up/-
down procedures.
Chapter 3: Operating the Equipment Locally
This chapter provides a guide to using the local Front Panel LCD user interface; describes the
menus, screens and options available to the user; and details the setting-up, configuration and
operating procedures.
Chapter 4: Operating the Equipment Remotely
This chapter provides a guide to configuring and preparing the unit for remote operation.
Chapter 5: Alarms
This chapter provides a guide to configuring the alarm interface.
Chapter 6: Options
This chapter describes the available hardware and software options for the IRD.
Chapter 7: Preventive Maintenance and Fault-Finding
This chapter details routine maintenance tasks to be performed; provides general servicing
advice, and information regarding warranty and maintenance; lists the error messages that
may occur, and any appropriate Operator action to be taken; provides general fault-finding
information for other types of problem which may be encountered; and provides relevant
disposal information.
Annex A: Glossary
Annex B: Technical Specification
Annex C: Menus
Annex D: Language Abbreviations
Annex E: Using the TT1260 with the TANDBERG Director System
Annex F: Factory Defaults
Reference Guide: TT1260 Contribution Receiver
ST.RE.E10100.3
Preliminary Pages
Page iii