Ethernet/Web Browser/Snmp; Remote Control - TANDBERG TT1260 Reference Manual

Installing the Equipment
Table 2.8: Frame Sync Hi-Z Connector
Item
Connector type
Connector designation
Pin:
Impedance
2.8.6

Ethernet/Web Browser/SNMP

The TT1260 has an Ethernet remote control port for SNMP or XPO
Control. This is also used for high-speed data over Ethernet output and
TANDBERG engineering debug purposes.
Table 2.9: Ethernet Pin-outs
Item
Connector type
Connector designation
Pin-outs
(Unused pins not connected)

Remote Control

Connect to a PC and use the System Menu 6.1.2 to switch between
the RS-232 and RS-485 input standards.
The specification for this connector is given in Section B.6.4, Remote
Connector. The Remote Control Protocol is published in manual
ST.TS.E10100.
Page 2-16
Specification
BNC 75 Ω socket
FRAME SYNC
Centre Analogue Black and Burst Input
Shield Ground/Chassis
Last unit must be terminated with 75 Ω
Specification
RJ-45 (100BaseT)
10/100BaseT
Pin 1  Tx Out (+)
Pin 2  Tx Out (-)
Pin 3  Rx In (+)
Pin 6  Rx In (-)
Reference Guide: TT1260 Contribution Receiver
ST.RE.E10100.3