Configuring The Unit For Remote Control Over The Air (Oac) - TANDBERG TT1220 Series Instruction Manual

Operating the Equipment Remotely
Table 4.1: Configuring the Communication Parameters
Step
1.
2.
3.
4.
5.
Once the communication parameters are entered correctly, set the system
into remote mode for the external computer to gain control of the unit.
Table 4.2: Activating RS-232 Remote Control
Step
1.
2.
3.
4.1.4 Configuring the Unit for Remote Control Over the Air
(OAC)
For the unit to be controlled via OAC, the control mode of the TT1220
needs to be set to OAC.
Table 4.3: Activating OAC Remote Control
Step
1.
2.
3.
Page 4-4
Action
Go to the remote menu, located under
the Advanced, RS-232 Setup
submenu in the setup menu.
Repeat pressing the up arrow, until you
are on the top line
Press right once, and then by using the
up and down arrows, key in the desired
baud rate.
Repeat for data bits, stop bits, parity
and flow control.
Once completed, the changes take
effect immediately.
Action
Go to the system options menu,
located under the Advanced submenu
in the setup menu.
Scroll until halfway down the menu,
where the item "Ctrl. Mode" is shown.
Press right once, and then by using the
up and down arrows, key in the desired
control mode, in this case: "remote".
Action
Go to the system options menu,
located under the Advanced submenu
in the setup menu.
Scroll until halfway down the menu,
where the item "Ctrl. Mode" is shown.
Press right once, and then by using the
up and down arrows, key in the desired
control mode, in this case: "OAC".
Result
The display will read "SET: REMOTE" on the top line.
The display will read "Baud rate:" on the bottom line.
The baud rate should be set to the same value as the
external control host.
All settings should be set to match the external control
host.
Result
The display will read "ADV: SYSTEM OPTIONS" on
the top line.
The unit is now ready to accept remote control via the
RS-232 port.
Result
The display will read "ADV: SYSTEM OPTIONS" on
the top line.
The unit is now ready to accept remote control via the
OAC protocol.
Instruction Manual: Professional Receivers and Decoders (IRD)
ST.TM.TT1220.1