Operating The Equipment From A Web Browser; Introduction; Receiver Web Browser Interface - TANDBERG RX8310 User Manual

4

Operating the Equipment From A Web Browser

4.1

Introduction

A PC Web Browser may be used to configure, control and monitor the Receiver.
The PC must be connected to either of the two IP control ports on the rear of the
receiver (labelled ETHERNET 1 and 2 or CONTROL 1 and 2). Before operation,
the User Settings for the control port must be entered via the system menu on the
front panel.
If the receiver is connected to an existing network or is not on the same subnet as
the control PC then assistance from the network administrator may be required in
modifying the User Settings.
To assist with troubleshooting, the IP control ports will respond to ICMP PING
request messages.
The reference guide contains more detail on all receiver User Settings available on
the Web Browser Interface.
4.2

Receiver Web Browser Interface

To use the receiver Web Browser Interface, the IP address assigned to the
receiver control port in the front panel system menu should be entered into the
address field of the Web browser.
Provided that the network is correctly configured, the following status page should
be automatically loaded and displayed.
RX8310/RX8315/RX8330 Distribution Receiver
13