Configuring Disk Clone - OVS LTN8608-P8 Quick Start Manual

User Manual
5. You can copy the quota settings of the current camera to other cameras if required. Click the Copy button
to enter the Copy Camera menu, as shown in Figure 12. 20.
6. Select the camera (s) to be configured with the same quota settings. You can also click the checkbox of IP
Camera to select all cameras.
7. Click the OK button to finish the Copy settings and back to the Storage Mode interface.
8. Click the Apply button to apply the settings.
If the quota capacity is set to 0, then all cameras will use the total capacity of HDD for record and picture capture.

12.6 Configuring Disk Clone

Purpose:
If the S.M.A.R.T. detection result declares the HDD is abnormal, you can choose to clone all the data on the HDD
to an inserted eSATA disk manually. Refer to Chapter 12.8 HDD Detection for details of S.M.A.R.T detection.
Before you start:
An eSATA disk should be connected to the device.
Steps:
User Manual of Network Video Recorder
Figure 12. 19 Configure Record/Picture Quota
Figure 12. 20 Copy Settings to Other Camera(s)
159